Used to partially delete a multi-line without losing any previously created breaks.
You can access this tool from the following:
- Ribbon:
- Toolbox:
Multi-lines
Setting | Description |
---|
Cap Mode |
Determines whether end caps are created and how they are defined:
- None — No caps are created. The end cap angle will be 90°. Effect is same as Cut All Component Lines tool.
- Current — Uses the start cap and end cap definitions of the selected multi-line.
- Active — Uses the active multi-line definition.
- Joint — Uses the selected multi-line's joint definition instead of end cap definition. Ensures end cap will always be 90°.
|
Key-in:
MLINE
PARTIAL
DELETE