To Publish the i-model Using the End-to-End Data Run (Administrator)
If you want a published i-model at the end of the End-to-End Data Run, enable the Publish .imodel command before running the End-To-End Data Run. To enable the command, right-click Publish .imodel and from the pop-up menu, select Enable Commands.
- In ConstructSim Executive, open your project (<project name>.vem).
- In the WorkFlow panel, go to and expand the node.
- Right-click Publish .imodel and from the pop-up menu, select Enable Commands.
-
Right-click the
End-to-End Data Run node and select Run.
At the completion of the End-To-End Data Run, the i-model is created and can be found in both of these locations:
- Use Bentley Navigator to open the i-model.