Front Stiffener / Back Stiffener
|
When checked, enables creating stiffeners on
respective side: front / back.
The following settings are enables for stiffener:
- Thickness –
Sets the thickness of the Stiffener Plates.
- Web
Offset – Sets the offset from the web of the supporting shape.
- Flange
Offset – Sets the offset from the inside flange of the supporting
shape.
- End
Offset – Sets the offset from the outer edge of the supporting
shape.
- Shape
Size(Type) –Sets one of the three types for the stiffener.
- Chamfered / Filleted /
Rounded – Sets one of the types of cut for the inner corners of the
Moment Plates. The inner corners are those nearest to the web of the supporting
member.
- Distance /
Radius – Sets the distance relating to the cut. (Radius, in case of
Fillet/Round corners). If 0, default values are retrieved from the database.
|
Vertical Stiffener
|
When checked, sets vertical stiffener:
- Thickness –
Sets the stiffener thickness selected from the drop-down list.
- Top
Length – Sets the top length of the stiffener.
- Bottom
Length – Sets the bottom length of the stiffener.
|