Galvanization holes
|
Sets the location of the galvanization holes to add
to the connection:
- None – No holes
are added.
- Web of
the connected shape – Additional holes are drilled in the web of
the column.
- Baseplate
– Additional holes are drilled in the baseplate.
|
Galvanization hole type
|
(Active for
Baseplate selection only).
Sets the hole pattern used for baseplate
galvaniztion holes.
- Center
hole - Single hole is added to the baseplate, at the geometric
center of the column.
- 2
holes - Two holes are added at opposing corners of the baseplate.
- 4
holes - Four holes are added, one in each quadrant of the
baseplate.
|
Distance from Flange
|
(Active for
Web of Connected Shape only).
Sets the distance from the inside of the column to
the center of the galvanization holes in the web.
|
Distance from Baseplate
|
(Active for
Web of Connected Shape only).
Sets the distance from the baseplate along the
length of the column to the centerline of the galvanization holes in the web.
|
X-Distance
|
(Active for
2 holes or
4 holes patterns in
Baseplate only).
Sets the horizontal spacing (parallel to column
web) of the galvanization holes, centered on the beam web. The default is
calculated as the column flange thickness plus two times the hole diameter.
|
Y-Distance
|
(Active for
2 holes or
4 holes patterns in
Baseplate only).
Sets the vertical spacing (parallel to column
flanges) of the galvanization holes, centered on mid-depth of the column. The
default value is calculated as the column depth minus two times flange
thickness minus two times the hole diameter.
|
Diameter
|
Sets the diameter of the galvanization holes in thebaseplate
or web of the column.
Tip: The
standard hole diameter per
DIN EN ISO 1461 is 20 mm.
|