Handrail outer post - junction
|
- Start /
End (Selection list) – Sets the form of the handrail’s end.
- Align
As Is – Leaves the alignment as is. No detailing takes place.
- To
outer edge – The handrail is extended up to the outer edge of the
post.
- Angle
cut – The handrail and the end post are cut to build a mitre joint.
- Insert bend
–The handrail and the end post are combined by means of a bent part. When
selected, activates the
Radius setting.
- Radius – Sets
the arc radius for rounding off. The value is defined either as absolute
numeric or as many times the amount of the handrail diameter. Enter e. g. *2.
|
Handrail outer oost - Junction with excess length
|
- Start /
End (Selection list) – Sets the form of the handrail’s end.
Additional shape parts are added in the handrail outside the end post.
- Align
As Is – Leaves the alignment as is. No detailing takes place.
- Angle
cut – The additional shape parts in the handrail are cut to build a
mitre joint.
- Insert bend
–The additional shape parts in the handrail are combined by means of a bent
part. When selected, activates the
Radius setting.
- Link with
/ Type
– The selected option sets the height the handrail
be extended to the bottom, by inserting a knee-high guardrail above, center or
below (if they exist), with an additional perpendicular part added.
- Upper
rail – Sets the cut / bend at the upper rail of the railing.
- Middle rail –
Sets the cut / bend at the middle rail of the railing.
- Insert bend
–Sets the cut / bend at the lower rail of the railing.
- Radius – Sets
the arc radius for rounding off. The value is defined either as absolute
numeric or as many times the amount of the handrail diameter. Enter e. g. *2.
- Close – When
checked, the handrail extends up to the end support after detailing.
|