Layout
|
Selects the shape of the cope. The different
variants are shown in the picture below:
Before
coping is shown (upper left, shapes overlap), contour (upper right). Bottom
from left to right:
Fit Shape Start
(the normal cope),
Fit Shape Middle and
Fit Shape End.
|
Corner Layout
|
- Edge – The
copes at the shape radii are carried out with a chamfer.
- Radial – The
copes at the shape radii are carried out with adapted radii. In the
Radius input field, the determined
radius can be modified later.
- Access Holes –
The holes are drilled in the inner corners of the cope. In the
Radius input field, the radius of the
drill holes can be preset.
|
From Inner Flange/Center
|
When
From Inner Flange is on, the
Distances are measured from the inner flange
edges. When off, the
Distances are measured from the outer flange
edges.
When
From Center is on, the
Distances are measured from the flange
center lines. When off, the
Distances are measured from the inner or
outer flange edges depending upon the
From Inner Flange setting.
1) Outer
edges, 2) Center lines
|
Distances
|
Note: Refer to the
Cope dialog preview for how the following
Distances are applied.
- Top
Flange Inside
- Top
Flange Edge
- Top
Flange Outside
- Web
Distance
- Bottom
Flange
- Bottom
Flange Edge
- Bottom
Flange
- Radius
|
+ Distance:
|
This value is added to the result of the function
GET FLANGE THICKNESS.
|
Both Sides Equal
|
The bottom of the notch is carried out with the data
of the top and the data are transferred into the fields.
|
Exchange Sides
|
The values of top and bottom are exchanged with each
other so that you can turn the connection.
|