To Create a Deployment Image
- Internet connection - Since the setup is running in /layout mode, internet connection is required for connection with Bentley servers to download all installable components.
- Write access to the location where the deployment image will be created.
- Minimum 2 GB disk space at the location where the deployment image will be created.
-
In the command line, go to the folder that contains the
OpenPlant Support Engineering
setup
executable and run the executable with the
/layout command. (Setup_<product_name>_<version>.exe/layout)
The OpenPlant Support Engineering Installation Wizard opens.
- (Optional)
To do Companion Installations (Companion Feature or Companion
Product) along with
OpenPlant Support Engineering
, do the
following. (Note that Companion Installations are not available for all
products)
- Turn on the check box for the desired Companion Installation.
- (Optional) Click Configure for the selected Companion Installation. The Installer Wizard displays the configuration settings for the selected Companion Installation.
- (Optional) Make the desired configuration settings and return to the Installer Wizard main page.
- (Optional)
To make changes to the default
OpenPlant Support Engineering
Configuration:
-
Click the
Configure button next to
OpenPlant Support Engineering
CONNECT Edition.
The Application Install Location page opens.
-
To change the path where
OpenPlant Support Engineering
is
installed, click the
Browse button
next to the
Application Path field.
In the Browse For Folder dialog that opens, browse to the drive and folder where you want to install OpenPlant Support Engineering , then click OK.
-
Click
Next.
The Configuration page opens.
-
To change the path of delivered Configuration, click the
Browse button
next to the
Configuration Path field.
In the Browse For Folder dialog that opens, browse to the drive and folder where you want to deliver the default Configuration, then click OK.
-
To set up custom or shared Configuration, select the
Custom Configuration (plus Delivered
Configuration) radio button. Then click the
Browse button
next to the
Network Configuration field.
In the Browse For Folder dialog that opens, browse to the drive and folder where your custom Configuration is located, then click OK.
-
Click
Next.
The Deployment Image Settings page opens.
-
Change the deployment image setting.
By default, Passive UI Mode is selected.
-
To change the deployment image location, click the
Browse button
next to the Deployment Image
Location path.
In the Browse For Folder dialog that opens, browse to the drive and folder you want to install the product in, then click OK.
-
Click
Next.
The Features page opens.
- In the Feature list, turn on or off the features, as desired.
- Click Done.
-
Click the
Configure button next to
OpenPlant Support Engineering
CONNECT Edition.
- Click Layout.
-
Click
Finish to exit the
OpenPlant Support Engineering
Installation Wizard.
The deployment image is created at the selected location.