Drawing Seed
|
Specifies the drawing seed that sets default values
for all of the values on the dialog except the start and stop locations. Also
contains definitions for what seed files are used to create the cross sections
drawing and seed models including how the drawings are positioned on the
sheets.
|
Detail Scale
|
Sets the scale at which the named boundary will be
placed.
|
Name
|
Enter name of the named boundary.
|
Description
|
Enter brief description for the new group.
|
Group
|
Selects the named boundary group. You can also create
a new group by selecting New from the drop-down.
|
Method
|
- Station Limits
- From Plan Group The
limits of the profile boundaries will match the plan boundaries in the
specified Plan Group.
|
Plan Group
|
Available if From Plan Group is selected as the
method.
|
Group
|
Selects the named boundary group. You can also create
a new group by selecting New from the drop-down.
|
Name
|
Enter name of the new group.
|
Description
|
Enter brief description for the new group.
|
Vertical Exaggeration
|
Specifies the vertical exaggeration for displayed
profile. Values greater than 1.0 for this parameter increase the exaggeration.
|
Available Profile Height
|
The depth of view in model units (unscaled) that the
profile view can display before needing to adjust and step the view.
|
Top Clearance
|
The height in model units (unscaled) above the profile
that is maintained relative to the design and or terrain models in the view.
|
Bottom Clearance
|
The height in model units (unscaled) below the profile
that is maintained relative to the design and or terrain models in the view.
|
Elevation Datum Spacing
|
When a profile is shifted, the starting elevation will
always be a multiple of this this value.
|
Station Datum Spacing
|
The rounding applied to the station location when
splitting the profile to generate stepped profiles.
|
Profile Shifts
|
Datum Stations, Where Needed or Do Not Shift
|
Use Terrains
|
Enable to use active surface information in drawing
the profile.
|
Use Active Vertical
|
Enable to use active vertical information in drawing
the profile.
|
Whole Conduits Only
|
Draws whole conduits on a sheet.
|
Create Drawing
|
Opens the Create Drawing dialog after creating the
named boundary to create a saved view from the selected named boundary and
automate dynamic views.
|
Show Dialog
|
When enabled, a dialog with additional parameters set
by the Drawing Seed is shown.
|