Bar Size
|
Sets bar size, and whether or not the
Stirrup zone.
|
Dispatch Method
|
Sets the dispatch method selected from the listed
options:
-
Vertex – Places Rebar between all
Vertices of the Line / Smartlines Connects all vertices.
(Distribution Values are ignored with this
Method & all lines / Smartlines must have same # of Vertices and/or
Segments)
-
Spacing – Places Bars at the Start and
End of the Line / Smartline / Arc or Spline.
(Offset values will shift Start and End bars
based on values entered) ignoring vertices then distributes bars equally across
remaining distance using indicated spacing (Not to exceed).
-
Combination – Combines Vertex and
Spacing Methods spacing the bars at the Start & End of each segment
(Offsets apply to each segment) then distributes bars equally across remaining
distance using indicated spacing (Not to exceed).
(All Lines / Smartlines must have same # of
Vertices and/or segments)
|
Stagger Length
|
Sets the length that staggers the bar laps.
|
Guidelines grid
|
The list table displays currently selected guideline elements.
|
Start Offset
|
Sets the offset at start.
|
Spacing
|
Sets the spacing between segments. Enabled for
Spacing and Combination dispatch methods.
|
End Offset
|
Sets the offset at end.
|
Override Qty
|
Sets the segment quantities. Applicable to Spacing
and Combination dispatch methods.
|