Plate
|
Used to define dimensions of a funnel:
|
Upper Length
|
Sets the length for upper opening of the funnel. Enter a positive
value to determine the length . A negative value will be read as its absolute
value while a zero value will set the previous value for the length. The
default is 1000 or 40 depending on the units setting.
|
Upper Width
|
Sets the width for upper opening of the funnel. Enter a positive
value to determine the width . A negative value will be read as its absolute
value while a zero value will set the previous value for the width . The
default is 800 or 32 depending on the units setting.
|
Lower Length
|
Sets the length for lower opening of the funnel. Enter a positive
value to determine the length . A negative value will be read as its absolute
value while a zero value will set the previous value for the length. The
default is 300 or 12 depending on the units setting.
|
Lower Width
|
Sets the width for lower opening of the funnel. Enter a positive
value to determine the width. A negative value will be read as its absolute
value while a zero value will set the previous value for the width . The
default is 200 or 8 depending on the units setting.
|
Height
|
Sets the height for the funnel. Enter a positive value to
determine the height . A negative value will flip the funnel up side down while
a zero value will set the previous value for the height. The default is 500 or
20 depending on the units setting.
|
Thickness
|
Sets the plate thickness for the funnel. Enter a positive value
to determine the thickness. A negative value will be read as its absolute value
while a zero value will set the previous value for the thickness. The default
is 20 or 0.8 depending on the units setting.
|
Options
|
Used to define placement option of a funnel:
|
Trim Top/Bottom
|
Trims the top and bottom ends of the plates if the box is ticked.
|
Insert Position
|
Sets the position of the plate funnel by selecting one of options
in the list.
|
Position
|
Sets the plate position.
- Outer
Limits – Uses the dimensions entered in dimensions column as outer
limits of the funnel.
- Inner
Limits – Uses the dimensions entered in dimensions column as inner
opening sizes of the funnel.
- Centreline
– Uses the dimensions entered in dimensions column
as measurements to the center line of the plates.
|
Connection Type
|
Defines the joint options between plates.
- Mitre
Cut – Applies mitre cut between two plates.
- Length
Trim – Using the plates along the length direction to trim the
plates along the width direction.
- Width
Trim – Using the plates along the width direction to trim the
plates along the length direction.
- No
Trim – Applies no cut to the plates
|