Post distribution
|
Specifies the approximate spacing of the rail posts
within the individual smartline segments.
- Normal – The
segment is regularly divided and the pre-determined post distance is adapted.
When set, enables the
Min segment settings below.
- Adjust Start –
The post distance of the default setting is kept and only the first part of the
segment is corrected.
- Adjust End –
The post distance of the default setting is kept and only the last part of the
segment is corrected.
- Adjust
Start/End – The post distance of the default setting is kept and
only the first and the last part of the segment are corrected equally.
|
Post distance
|
Sets the post spacing. it is the distance of the
rail posts within the individual smartline segments. Depending on the setting,
the program uses this information to space out the newel posts in regular
intervals and rounds the value up or down as needed.
- Maximum – When
checked, the values of the determined post distances are never rounded up. The
post distance is regarded as the maximum value. If necessary, additional posts
are inserted.
|
Edge offset
|
Seats the spacing of the corner posts between two
handrail segments starting with the intersection of the smartline segments.
|
Min. segment length
|
Sets the minimum length of a handrail segment from
which on posts are created. Thus advised to avoid e. g. the creation of posts
at the inner edge of intermediate landings at staircases with changing
direction.
|
Min. segment 2 posts
|
Sets the minimum length of a handrail segment from
which on two posts are created at the beginning and at the end. If the actual
length is smaller (but larger than the 'Minimum Segment
Length’), only one post will be created in the middle of the segment.
|