Used to set plate dimensions and holes on the end plate.
Setting | Description |
---|
Dimensions
|
- Length – Sets
the length of the end plate. A positive value determines the length. A negative
value is to be read as its absolute value. The default is 400 or 16 depending
on the units setting.
- Width – Sets
the width of the end plate. A positive value determines the width. A negative
value is to be read as its absolute value. The default is 400 or 16 depending
on the units setting.
- Thickness –
Sets the thickness for the end plate. A positive value determines the
thickness. A negative value is to be read as its absolute value. The default is
10 or 0.5 depending on the units setting.
|
Holes
|
- Match
Strap – When checked, the hole size (diameter) and position is
based on the strap. Disables
Diameter.
- Diameter – Sets
the diameter of the holes in the end plate. A positive value determines the
diameter. Default is 16 or 0.625 depending on the units setting.
- Workloose –
Sets the allowance for the holes workloose for the hole in the end plate. A
positive value determines the workloose. Default is 1 or 0.05 depending on the
units setting.
- Vertical
Spacing – Sets the distance between the holes in vertical
direction. A positive value determines the distance. A negative value is to be
read as its absolute value. The default is 175 or 7 depending on the units
setting.
|