Shaft Profile
|
STAAD Foundation Advanced can design both Straight and (angle) Belled drilled piers. The BD, ST, and BT dimensions are only used for Belled shafts.
|
Pier Ht Above Ground (PG)
|
Measured from ground elevation to top of shaft, with selected units.
|
Shaft Diameter (SD)
|
Diameter of main shaft, with selected units.
|
Pier Height (PH)
|
Total pier height, measured from top of shaft above ground to bottom of bell (if present) or shaft bearing end, , with selected units.
|
Water Level (WL)
|
Measured from Ground Elevation (GE), with selected units.
|
Ground Elevation (GE)
|
Arbitrary elevation value, with selected units.
|
Bell Diameter (BD)
|
(Belled only) Diameter of belled shaft end, with selected units.
|
Slope Thickness (ST)
|
(Belled only) The height of the sloped portion of the bell, with selected units.
|
Bell Thickness (BT)
|
(Belled only) Height of bell from bottom to toe of sloped portion, with selected units.
|
< Previous
|
Steps the Wizard to the previous step.
|
Next >
|
Proceeds the Wizard to the next step.
|
Cancel
|
Exits the Wizard without creating a new Drilled Pier Job.
|