Join Method
|
The following methods can be used to join the two
duct sections.
- Elbow - Joins with an elbow/bend
fitting for any angle.
- Take Off - Joins perpendicular
and angled take off intersections with a take off fitting. Default take off
fittings are selected from the available catalogs.
- Transition - Joins the two ends
of the ducts using a transition with the defined maximum angle.
|
Tolerance
|
Sets the maximum allowable linear distance between
two ducts. Centers must be within the allowable tolerance distance to be
joined. If the distance between the centers of the selected components is
greater than the allowed distance, the tolerance must be increased to join the
two successfully.
|
Maximum Angle
|
Maximum angle is used to calculate run and rise
offset for the transition.
Note: This field
only enables if the
"Join with Transition" option is selected.
|